Graphics Programs Reference
In-Depth Information
The second parcel-layout parameter is Remainder Distribution, which
determines what is done with the “leftover” area after all parcels that meet
the size requirements have been created. The Remainder Distribution options
are as follows:
Create Parcel From Remainder A new parcel is created that is smaller than
the specified sizing parameters.
Place Remainder in last Parcel The last parcel is oversized by adding the
remainder to it.
Redistribute Remainder All parcels are oversized by a small amount so that
the leftover area is spread across all parcels.
Exercise 12.4: Create Multiple Parcels
In this exercise, you'll create multiple parcels by using the Slide Line Create
command with Automatic Mode turned on.
If you haven't already
done so, download
and install the files for
Chapter 12 according to
the instructions in the
Introduction.
1. Open the drawing named Using Parcel Sizing Parameters.dwg
located in the Chapter 12 class data folder.
2. On the Home tab of the ribbon, click Parcel  Parcel Creation
Tools. On the Parcel Layout Tools toolbar, change Automatic Mode
to On.
3. Click Slide Line - Create, and then click OK to dismiss the Create
Parcels - Layout dialog box. When you're prompted to select a parcel,
click the label that reads Property : 30.
Automatic Mode sub-
divides the area into as
many parcels as possible
while maintaining the
current parcel-size
requirements.
4. When you're prompted for the start point of the frontage, snap to the
endpoint of the right-of-way line at the entrance of Jordan Court, as
shown in Figure 12.13.
FiGuRE 12.13 Selecting the beginning point of the frontage
Search WWH ::




Custom Search