Graphics Programs Reference
In-Depth Information
7. When you're prompted to specify the angle, type 90 at the command
line, and press Enter.
A preview of the new parcel appears near the start point of the
frontage.
Because 90 ° is the
default, you could
simply press Enter when
prompted for the angle.
8. Press Enter to accept the current sizing parameters and create
the parcel. Press Esc to exit the current command but keep the
Parcel Layout Tools toolbar open.
9. Click Swing Line - Create, and click the label that reads Property : 2
near the southeastern corner of the project.
10. When you're prompted for the start point of the frontage, snap to the
northern endpoint of the Property : 2 parcel, as shown in Figure 12.11.
FiGuRE 12.11 Selecting the beginning
point of the frontage
11. When you're prompted for the endpoint of the frontage, move your
cursor in a westerly direction along the property line and snap to the
western endpoint of the same parcel (see Figure 12.12).
To use an Endpoint
object snap, hold
down the Shift key
and right-click; then
select Endpoint.
FiGuRE 12.12 Selecting the
ending point of the frontage
12. When you're prompted for the swing point, use an Endpoint object
snap to select the property corner just south of the Property : 2 label.
A preview of the parcel is displayed using the current Minimum
Area setting of 10890 Sq. Ft. (1500 sq.m.).
Search WWH ::




Custom Search