Graphics Programs Reference
In-Depth Information
Tip
You can also nudge the selected letter with the arrow keys or press
Shift+arrow key to move the letter in bigger increments.
12.
Click to select the second letter “O” in “ZOO,” and change the following using the
Touch Type tool:
• Rotate the letter clockwise -35° (clockwise rotation shows a negative value).
• Click and drag (what was) the upper-right corner of the box, away from the cen-
ter, until you see roughly 105% for width (W:) and height (H:) in the measure-
ment label.
• Drag the letter from the center into the position you see in the figure.
Note
There are limits to how far you can drag in any direction. Those limits are
based on the kerning and baseline shift value limits.
13.
Click to select the letter “T” in “TALES,” and change the following using the
Touch Type tool:
• Click and drag the upper-right corner of the box, away from the center, until
you see roughly 150% for width (W:) and height (H:) in the measurement label.
• Drag the letter “T” from the center down and to the left (a bit closer to the
second “O” in “ZOO”), into the position you see in the figure.
• Click and drag the upper-left point up until you see a Vertical Scale of 185%.
