Graphics Programs Reference
In-Depth Information
FIGURE 6.5 Start the new rectangle based on the corner of the first.
FIGURE 6.6 Adding a parallel line
In Inventor, you can create an arc tangent to a line by moving your
cursor over the endpoint of a line segment and then clicking and drag-
ging your mouse off the end of the line. You can use the same tech-
nique to create an arc that ends normal to the end of a line segment.
5. With the Line tool still active, hover over the last point you selected.
6. When the gray dot appears, click and drag your mouse to the right of
the endpoint. This should generate an arc like that shown in Figure 6.7.
Search WWH ::




Custom Search