Designing Roads - Autodesk Roadway Design for Infraworks 360 Essentials - page 51

4. Click the bypass road to highlight it and
show the Road asset card.
5. If the Edit Mode section is not visible on the
Road asset card, right-click the road and
select Edit. Set Edit Mode to Geometry.
6. Right-click the green pushpin located near
the end of the road. Select Add Point.
After a pause, a new PI will be created at the
location of the green pushpin.
7. Click the purple cube gizmo at the end of the
road and drag it to the other green pushpin
to the north. Release it at the location of the
pushpin.
As you drag the end of the road to the new
location, you can see the curve develop at
the PI that you just created.
8. Right-click the new curve and select Spiral
Curve Spiral.
After a pause, you will see the curve broken
into segments: two orange spiral segments
and one blue curve segment.
9. Right-click the curve and move your cursor
over the Edit Curve selection.
The menu will expand to reveal sliders for
the curve and spiral geometry.
10. Set Curve Radius to 2500 ( 765 ) and Spiral
Length to 350 ( 100 ), as shown in Figure