Designing Roads - Autodesk Roadway Design for Infraworks 360 Essentials - page 50

Add Culverts Available only if
Drainage Design for InfraWorks 360 is
enabled.
Properties Opens the properties panel
and displays the properties for the road.
Exercise 2.3: Edit a Road Using Context
Menus
In this exercise you will use context menus to
add a new section of road to the Bimsville
Bypass.
If you are continuing from the previous
exercise, you can skip to step 3. Otherwise, if
you haven't already done so, go to the topic's
web page at www.sybex.com/go/
roadwayessentials and download the files for
Chapter 2. Unzip the files to the correct location
on your hard drive according to the instructions
in the introduction.
1. If it is not already open, launch InfraWorks
360.
2. On the Start Page, click Open and browse to
C:\InfraWorks Roadway
Essentials\Chapter 02\ . Click Ch02
Bimsville Roads.sqlite and click
Open.
3. Select the Ex_2_3 proposal. Restore the
bookmark named PI-3.