Designing Roads - Autodesk Roadway Design for Infraworks 360 Essentials - page 88

After a pause, the intersection geometry will
change dramatically. This type of truck will
need to be accommodated for the
intersection area.
7. Click the northern turning zone to select it.
Click the purple cylinder gizmo and drag it
to the right as shown in Figure 2-42 . Release
when the red dotted outline of the widening
zone appears.
Figure 2-42: Creating a widening zone
8. Click the widening zone. On the Widening
Zone asset card, do the following:
• Under Attributes, set Widening Length
to 100 ( 30 ).
• Under Transition, set Length to 100
( 30 ).
• Under Transition, verify that Type is set
to Linear.