Hardware Reference
In-Depth Information
Insert the tip of a flat-blade or Phillips screwdriver in the hole in the center of
the steel RF shield inside the drive bay and twist it back and forth, as shown in
Figure 4-18, until the metal plate snaps free.
Figure 4-17.
Snap out the top 5.25” drive bay bezel
Figure 4-18.
Twist the metal RF shielding plate until it snaps free
Locate two drive rails and four optical drive mounting screws in the parts box.
Stand the optical drive on its side on your work surface, and align one of the
drive rails with the mounting holes in the side of the optical drive. Position the
drive rail so that it is about centered vertically on the side of the optical drive,
with the front of the metal spring tab flush with the front bezel of the drive. In-
sert two screws to secure the drive rail to the optical drive, as shown in Figure
4-19. Repeat this procedure to install the second drive rail.
Position the optical drive in the drive bay and slide it into the drive bay, as
shown in Figure 4-20, until the spring clips on both drive rails snap into place.
Verify that the front bezel of the drive is seated flush with the front bezel of
the case.
Figure 4-19.
Use two screws to secure the drive rail to the optical
drive
Figure 4-20.
Slide the optical drive into the bay and press until
both spring clips on the drive rails snap into place
