Hardware Reference
In-Depth Information
Using a web server will allow you to access your Arduino via the LAN cable that will be
connected to your ROV from a web browser on a computer at the surface. To connect
with the device, you'll need to set the appropriate address for the Arduino web page.
To do this, run
ipconfig
from the command prompt (under the
Accessories
folder) on
your computer. When you run this, you should see something like the following screen-
shot:
You'll now need to edit the
WebServer
sketch to set a new address that uses the same first
two numbers in the address. This is where you'll change the code as follows: