Hardware Reference
In-Depth Information
Connecting a sonar sensor to Arduino
Here is an image of a sonar sensor, HC-SR04, which works well with Arduino:
These sonar sensors are available at most places that sell Arduino products, including
amazon.com
.
In order to connect this sonar sensor to your Arduino, you'll need some of
those female-to-male jumper cables that you used in the previous chapters. You'll notice
that there are four pins to connect the sonar sensor. Two of these supply the voltage and
current to the sensor. One pin, the Trig pin, triggers the sensor to send out a sound wave.
The Echo pin then senses the return from the echo.
To access the sensor with Arduino, make the following connections using the male-to-fe-
male jumper wires:
Arduino pin
Sensor pin
5V
Vcc
GND
GND
12
Trig
11
Echo
