Hardware Reference
In-Depth Information
Figure 3-11.
The final connections in standard mode
6.
Now go ahead and pull everything but the DS1820B off your breadboard. Once again, start
off by connecting your jumper wires. Connect pin 1 to ground as shown in Figure
3-11
.
Now place a jumper between pin 1 and pin 3. According to the data sheets for the DS1820B
you must tie the Vdd line to the GND line. You're going to need to place a jumper wire
out from pin 2 to a new row on the breadboard. Take a look at Figure
3-12
: it will be much
easier to see how I have done it.
Figure 3-12.
Jumpers for the parasite mode installed