Digital Signal Processing Reference
In-Depth Information
1.8 Downloading Your Design to the UP2 or UP1 Board
Hooking Up the UP1 or UP 2 Board to the Computer
To try your design on a UP1 or UP2 board, plug the ByteBlaster cable into the
UP board (top left) and attach the other end to the parallel port on a PC. If you
have not done so already, make sure that the PC's BIOS settting for the printer
port is ECP or EPP mode. Using a 9V AC to DC wall transformer or another 7
to 9V DC power source, attach power to the DC power connector (DC_IN)
located on the upper left-hand corner of the UP3 board. When properly
powered, one of the green LEDs on the board should light up.
Figure 1.18
ALTERA UP2 board with jumper settings and PB1, PB2, and LED locations.
Verify that the device jumpers are set for the FLEX chip as shown in Table 1.2.
The locations of the pushbuttons, PB1 and PB2, and the LED decimal point are
also highlighted in Figure 1.18. (Note that for the MAX EPM7128 chip, the
jumper pins are all set to the top position as indicated in Table 1.2.)
Table 1.2 Jumper settings for downloading to the MAX and FLEX devices.
