Information Technology Reference
In-Depth Information
Task 7: Documentation
On each router, capture the following command output to a text (.txt) file and save for future reference:
show running-config
■
show ip route
■
show ip interface brief
■
show ip protocols
■
If you need to review the procedures for capturing command output, refer to “Lab 1-1: Cabling a
Network and Basic Router Configuration.”
Task 8: Clean Up
Erase the configurations and reload the routers. Disconnect and store the cabling. For PC hosts that
are normally connected to other networks (such as the school LAN or the Internet), reconnect the
appropriate cabling and restore the TCP/IP settings.
Packet Tracer Companion: OSPF Troubleshooting (11.6.3)
Packet Tracer
Companion
You can now open the file LSG02-Lab1163.pka on the CD-ROM that accompanies this topic to repeat
this hands-on lab using Packet Tracer. Remember, however, that Packet Tracer is not a substitute for a
hands-on lab experience with real equipment.
Packet Tracer Skills Integration Challenge: OSPF
Configuration
Packet Tracer
Challenge
Upon completion of this challenge, you should be able to
Design and document an addressing scheme based on requirements
■
Apply a basic configuration to the devices
■
Configure a router's priority and router ID
■
Configure OSPF routing
■
Disable routing updates on appropriate interfaces
■
Verify full connectivity between all devices in the topology
■
Open the file LSG02-PTSkills11.pka on the CD-ROM that accompanies this topic. You will use the
topology in Figure 11-15 and the addressing table in Table 11-6 to document your design.
