Information Technology Reference
In-Depth Information
Configure the Ethernet interfaces of PC1, PC2, and PC3 with the IP addresses from the
table provided under the topology diagram.
Step 2.
Configure the correct bandwidth for the serial interfaces on the Branch1 router.
Step 3.
What commands are required to accomplish this?
configure terminal
interface serial0/0/0
bandwidth 128
interface serial 0/0/1
bandwidth 64
Configure the correct bandwidth for the serial interfaces on the Branch2 router.
Step 4.
What commands are required to accomplish this?
configure terminal
interface serial0/0/0
bandwidth 64
interface serial 0/0/1
bandwidth 256
Configure the correct bandwidth for the serial interfaces on the HQ router.
Step 5.
What commands are required to accomplish this?
configure terminal
interface serial0/0/0
bandwidth 128
interface serial 0/0/1
bandwidth 256
Task 6: Verify Connectivity to the Next-Hop Device
You should
not
have connectivity between end devices yet. However, you can test connectivity
between the two routers and between an end device and its default gateway.
Verify that the HQ, Branch1, and Branch2 routers can ping each of the neighboring routers
across the WAN links.
Step 1.
Verify that PC1, PC2, and PC3 can ping their respective default gateway.
Step 2.
Task 7: Configure OSPF Routing on the Branch1 Router
Consider the networks that need to be included in the OSPF updates that are sent out by
the Branch1 router.
Step 1.
