OSPF - Routing Protocols and Concepts - page 521

Last flood scan length is 1, maximum is 1
Last flood scan time is 0 msec, maximum is 0 msec
Neighbor Count is 1 , Adjacent neighbor count is 1
Adjacent with neighbor 10.2.2.2
Suppress hello for 0 neighbor(s)
Serial0/0/1 is up, line protocol is up
Internet address is 192.168.10.5/30, Area 0
Process ID 1, Router ID 10.1.1.1, Network Type POINT-TO-POINT, Cost: 390
Transmit Delay is 1 sec, State POINT-TO-POINT,
<output omitted>

Use the ip ospf cost command to configure the OSPF cost on the R3 router. Step 5.

An alternative method to using the bandwidth command is to use the ip ospf cost com-
mand, which allows you to directly configure the cost. Use the ip ospf cost command to
change the bandwidth of the serial interfaces of R3:

R3(config-if)# interface serial0/0/0
R3(config-if)# ip ospf cost 390

Use the show ip ospf interface command on the R3 router to verify that the cost of each
of the serial links is now 781.

Step 6.

R3# show ip ospf interface

<output omitted>

Serial0/0/1 is up, line protocol is up
Internet address is 192.168.10.10/30, Area 0
Process ID 1, Router ID 10.3.3.3, Network Type POINT-TO-POINT, Cost: 781
Transmit Delay is 1 sec, State POINT-TO-POINT,
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:06
Index 2/2, flood queue length 0
Next 0x0(0)/0x0(0)
Last flood scan length is 1, maximum is 1
Last flood scan time is 0 msec, maximum is 0 msec
Neighbor Count is 1 , Adjacent neighbor count is 1
Adjacent with neighbor 10.2.2.2
Suppress hello for 0 neighbor(s)
Serial0/0/0 is up, line protocol is up
Internet address is 192.168.10.6/30, Area 0
Process ID 1, Router ID 10.3.3.3, Network Type POINT-TO-POINT, Cost: 390
Transmit Delay is 1 sec, State POINT-TO-POINT,
<output omitted>