Information Technology Reference
In-Depth Information
Configure a password for VTY connections.
■
Synchronize unsolicited messages and debug output with solicited output and prompts for the
console and virtual terminal lines.
■
Configure an EXEC timeout of 15 minutes.
■
Task 5: Configure and Activate Serial and Ethernet
Addresses
Configure the interfaces on the HQ, BRANCH1, and BRANCH2 routers.
Step 1.
Configure the interfaces with the IP addresses from Table 9-6.
When you have finished, be sure to save the running configuration to the NVRAM of the
router.
Configure the Ethernet interfaces.
Step 2.
Configure the Ethernet interfaces of PC1, PC2, and PC3 with the IP addresses from Table
9-6.
Task 6: Verify Connectivity to the Next-Hop Device
You should
not
have connectivity between end devices yet. However, you can test connectivity
between two routers and between an end device and its default gateway.
Verify connectivity of routers.
Step 1.
Verify that the HQ, BRANCH1, and BRANCH2 routers can ping each of the neighboring
routers across the WAN links.
Verify connectivity of PCs.
Step 2.
Verify that PC1, PC2, and PC3 can ping their respective default gateways.
Task 7: Configure EIGRP Routing on the BRANCH1 Router
Consider the networks that need to be included in the EIGRP updates that are sent out by the
BRANCH1 router.
What directly connected networks are present in the BRANCH1 routing table?
172.16.2.0
192.168.1.16
192.168.1.24
Will these networks need to have the subnet mask information included in the network statements?
yes
What commands are required to enable EGIRP and include the connected networks in the routing
updates?
router eigrp 1
network 172.16.2.0 0.0.0.255
network 192.168.1.16 0.0.0.3
network 192.168.1.24 0.0.0.3
