Information Technology Reference
In-Depth Information
configure terminal
router rip
no passive-interface Serial 0/0/0
passive-interface FastEthernet 0/0
If you have recorded any commands, apply them to the router configuration now.
Step 6.
View the routing information.
Step 7.
If any changes were made to the configuration in the previous steps, view the routing
information again.
Does the information in routing table indicate any configuration errors?
no
Does the information included in the RIP updates that are sent out indicate any configura-
tion errors?
no
If the answer to either of these questions is
yes
, troubleshoot the routing configuration
again.
What networks are included in the RIP updates?
0.0.0.0
10.45.2.0
Verify that the HQ router is sending a default route to the BRANCH router.
Step 8.
Is there a default route in the BRANCH routing table?
no
If not, what commands are needed to configure this on the HQ router?
configure terminal
router rip
default-information originate
If you have recorded any commands, apply them to the HQ router configuration now.
Step 9.
View the BRANCH routing table.
Step 10.
If any changes were made to the configuration in the previous step, view the BRANCH
routing table again.
Is there a default route in the BRANCH routing table?
yes
If the answer is
no
, troubleshoot the RIP configuration again.
Attempt to ping between the hosts again.
Step 11.
From the host PC2, is it possible to ping PC1?
yes
From the host PC2, is it possible to ping the Serial 0/1 interface of the ISP router?
no
From the host PC1, is it possible to ping PC3?
yes
