Information Technology Reference
In-Depth Information
Lab 5-2: Challenge RIP Configuration (5.6.2)
Upon completion of this lab, you will be able to
Subnet an address space given requirements
■
Assign appropriate addresses to interfaces and document them in the addressing table
■
Cable a network according to the topology diagram in Figure 5-13
■
Erase the startup configuration and reload a router to the default state
■
Configure RIPv1 routing on all routers
■
Configure and propagate a static default route
■
Verify RIPv1 operation
■
Test and verify full connectivity
■
Reflect on and document the network implementation
■
Table 5-6
Addressing Table for Lab 5-2
Device
Interface
IP Address
Subnet Mask
Default Gateway
BRANCH
Fa0/0
10.10.2.1
255.255.254.0
—
S0/0/0
192.168.1.126
255.255.255.192
—
HQ
Fa0/0
192.168.1.129
255.255.255.192
—
S0/0/0
192.168.1.65
255.255.255.192
—
S0/0/1
209.165.200.226
255.255.255.252
—
ISP
Fa0/0
209.165.202.129
255.255.255.224
—
S0/0/1
209.165.200.225
255.255.255.252
—
PC1
NIC
10.10.3.254
255.255.254.0
10.10.2.1
PC2
NIC
192.168.1.190
255.255.255.192
192.168.1.129
PC3
NIC
209.165.202.158
255.255.255.224
209.165.202.129
Scenario
In this lab activity, you will be given a network address that must be subnetted to complete the
addressing of the network shown in Figure 5-13. A combination of RIPv1 and static routing will be
required so that hosts on networks that are not directly connected will be able to communicate with
each other. Use the information in Table 5-6 for reference. Step 2 of Task 2 asks you to complete the
information in Table 5-6 for documentation purposes.
