Information Technology Reference
In-Depth Information
Task 2: Apply a Basic Configuration
Using your documentation, configure the routers with basic configurations including addressing. Use
cisco
as the line passwords and
class
as the secret password. Use
64000
as the clock rate.
Task 3: Configure Static and Default Routing
Configure static and default routing using the exit interface argument:
R1 should have four static routes and one default route.
■
B1, B2, B3, and B4 should have one default route each.
■
ISP should have two static routes: one for the WAN address space and one for the LAN address
space.
■
Task 4: Test Connectivity and Examine the Configuration
Test connectivity.
Step 1.
You should now have end-to-end connectivity. Use ping to test connectivity across the
network. Each router should be able to ping all other router interfaces and the web server.
■
Use extended ping to test LAN connectivity to the web server. For example, the test
the Fa0/0 interface on B1, you would do the following:
B1#
ping
Protocol [ip]:
Target IP address:
209.165.200.226
Repeat count [5]:
Datagram size [100]:
Timeout in seconds [2]:
Extended commands [n]:
yes
Source address or interface:
10.1.0.1
Type of service [0]:
Set DF bit in IP header? [no]:
Validate reply data? [no]:
Data pattern [0xABCD]:
Loose, Strict, Record, Timestamp, Verbose[none]:
Sweep range of sizes [n]:
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 209.165.200.226, timeout is 2
seconds:
Packet sent with a source address of 10.1.0.1
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 67/118/138
ms
■
Troubleshoot until pings are successful.
■
Examine the configuration.
Step 2.
Use verification commands to make sure that your configurations are complete.
