Information Technology Reference
In-Depth Information
Your completion percentage should be 39%. If not, click
Check Results
to see which
required components are not yet completed.
Step 2.
After completing this task, save your Packet Tracer file to use again in the next section. Save the file
as LSG02-0201-task2.pkt.
Router Configuration Review
To configure static routing and dynamic routing protocols, you need to know only the basic IOS com-
mands. You should already be familiar with these commands. The following sections are only meant
as a review. For more detailed explanations, refer to Chapter 1 and the Network Fundamentals course.
show Commands Matching Exercise
Using only the partial output shown, indicate which command displayed this output.
R1#
show running-config
or
show startup-config
<output omitted>
!
hostname R1
!
!
enable secret 5 $1$.3RO$VLUOdBF2OqNBn0EjQBvR./
<output omitted>
R1#
show interfaces
or
show interface [any fastethernet interface]
<output omitted>
Hardware is AmdFE, address is 000c.3010.9260 (bia 000c.3010.9260)
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
<output omitted>
R1#
show ip interface brief
<output omitted>
FastEthernet0/0 unassigned YES manual administratively down down
<output omitted>
R1#
show ip route
<output omitted>
* - candidate default, U - per-user static route, o - ODR
P - periodic downloaded static route
Gateway of last resort is not set
<output omitted>
