Information Technology Reference
In-Depth Information
7.
In the
Properties
(
N
) sidebar set the dimensions to
X:
20
,
Y:
20
,
Z:
15
, set
the location to
X:
27
,
Y:
13
,
Z:
-21
, and set the rotation to
X:
0
,
Y:
90
,
Z:
0
.
(Some adjustment in the y axis may be necessary after placement based on
where the rack may be sitting after the simulated presses. Try to make the
RackFingerHole
so it is approximately 2mm from the edge of the rack's
finger space all around.)
8.
Add a
Boolean
modifier to the rack to
Difference
the
RackFingerHole
from it.
Docking the spring
The rack is almost complete with the exception of something to hold the spring in
place. For this a small protrusion small enough for the spring to go around should
do. Refer back to the measurements of the spring taken at the beginning. The inside
of the spring was approximately 3mm in diameter.
1.
This connection should be snug so
Add
(
Shift
+
A
) a cylinder with a radius of
1.5
and a depth of
3
. Name it
RackPeg
.
Move
(
G
) it
23
along the x axis (
X
)
and move (
G
) it along the y axis (
Y
) until it sticks just below the bottom of the
rack, or about
-18
if the rack is exactly where it started.