Graphics Programs Reference
In-Depth Information
FiGuRE 2.31 Selecting a line to be a boundary edge
4. Pick the two new vertical lines created by the OFFSET command. Be
sure to place the pickbox somewhere on the lower halves of these
lines or AutoCAD will attempt to extend the opposite ends of the lines.
Because there are no boundary edges that could intersect with exten-
sions from the top end of the lines, AutoCAD will apparently ignore
your picks if you select the wrong ends. The lines are extended to the
boundary edge line.
5. Press to end the EXTEND command (see Figure 2.32).
FiGuRE 2.32 The lines are extended to the boundary edge.
 
Search WWH ::




Custom Search