Graphics Programs Reference
In-Depth Information
X direction. The first set of railing posts should look like those shown
in Figure 16.57.
FiGuRE 16.56 Creating the first railing post cylinder
TIP rather than manually copying the railing post 20 times, try using
the ARRAY command. this command includes the source object in the row
and column count, so to use it to complete step 8 you'll need to create an
array with 1 row and 21 columns.
9. Repeat steps 5 through 8 to draw the posts along the front of the
deck, adjusting the count and the direction appropriately; then copy
the posts from the left side of the deck to the right. Add any new post
as required. The completed railing posts should look like those shown
in Figure 16.58.
10. Zoom into the front-left corner of the deck, where the support post
sits. Use the Box tool to draw the 8 ″× 8″ (204 mm × 204 mm) post and
give it a height of 7 -8 (2337). You may need to adjust the height
later when the roof is applied.
11. Copy the post to the opposite side of the deck and adjust the placement
as necessary. Figure 16.59 shows the two support posts in place.
 
Search WWH ::




Custom Search