Learning Basic Commands to Get Started - AutoCAD 2011 and AutoCAD LT 2011: No Experience Required - page 60

TIP When the radius value is set higher than 0, you can temporarily
override this by holding the Shift key down while picking the two objects to
be filleted. they will be filleted with a radius of 0, while the value set in the
FILLET command remains unchanged.

the down-pointing
arrow next to the
Fillet tool opens
a fly-out menu
that includes the
Chamfer tool.

3. Move the cursor — now a pickbox — to the shape, and click two inter-
secting lines, as shown in Figure 2.24. The intersecting lines are both
trimmed to make a sharp corner (see Figure 2.25). The FILLET com-
mand automatically ends.

Pick these two lines near
these locations.

Y

X

FiGuRE 2.24 Pick two lines to execute the FILLET command.

FiGuRE 2.25 The first cleaned-up corner

4. Press ↵ to restart the command, and this time enter M ↵ to activate the
Multiple option . Multiple repeats the FILLET command until another