Using Layouts to Set Up a Print - AutoCAD 2011 and AutoCAD LT 2011: No Experience Required - page 764

the Floor Plan Materials Sheet

Similar to the Floor Plan sheet you just finished, you'll apply a series of viewport
overrides to the Floor Plan Materials sheet. This time you'll be changing the vis-
ibility of the grid, dimension, and door tag layers.

1. Make sure A-100.dwg is open, and switch to the Floor Plan Materials
A-102 layout.

2. Double-click into the viewport, and use the Freeze ( LAYFRZ ) tool to
select any of the dimensions.
The 14A-FPLAY1|A-ANNO-DIMS layer is frozen in the current
viewport only.

3. Use the Freeze tool once again to select one of the vertical grid
lines above the floor plan. Selecting one of these lines freezes the
14A-FPLAY1|A-GRID layer.

4. Finally, use the Freeze tool to select one of the door tags to freeze the
14A-FPLAY1|A-ANNO-TABL layer.

a U t o Cad lt U s e r s

You'll need to update the Drawing Title block manually to match the sheet
title, since Sheet Set Manager is not available in AutoCAD LT.

1. Double-click the Drawing Title block to open the Enhanced Attribute

Editor.

2. Change the VIEWNAME tag to Floor Plan Materials, and Click OK to

return to the drawing.

3. Using the Enhanced Attribute Editor once again, change the Sheet

Number (lower-right corner) to A-102.

5. The Drawing Title block is a dynamic block. Click it and then drag
the right end of the horizontal line to the right until it extends
underneath the entire title. (See Figure 14.68.)

6. You may choose to use the PAN command to better orient the floor
plan on the Plan Materials sheet. When finished, your drawing should
look like Figure 14.69.