Graphics Programs Reference
In-Depth Information
2. Set up a UCS for the left elevation. (Click the Z button in View tab
Coordinates panel, and then enter 180 .) Use the PLAN command to
rotate the drawing to the current UCS.
3. Revise the elevation to match the left side of the cabin.
a. Temporarily move the railing posts a known distance and angle
away from their current locations.
b. Use the STRETCH command and Perpendicular osnap to stretch
the stairway and railings to match the stairway location on the
back of the cabin as shown on the floor plan.
c. Move the railing posts back to their original locations.
d. Add or delete posts as required.
e. Delete the sliding door frame that divides the left and right pan-
els, and then adjust the door to match the extents shown on the
plan view.
f.
Move the wall lines to the A-ELEV-WALL layer.
g. Add the window with the lower edge at 2 -11 (889 mm) above the
base line and the top edge at 7 -11 (2413 mm) above the base line.
When you're done, the elevation should look like Figure 10.51.
4. Name and save the UCS and view (call them both West_elev).
FiGuRE 10.51 The completed rear elevation
 
Search WWH ::




Custom Search