Graphics Programs Reference
In-Depth Information
In the case of Annotation Visibility, the on position is represented
by a yellow lightbulb, and for Automatically Add Scales, a yellow
lightning bolt is used.
2. Change the annotation scale to ¼ = 1 -0 .
The KITCHEN, LIVING ROOM, and BATH text size changes to
reflect the newly selected annotation scale.
3. Select the BATH text, and start the MOVE command found on the
Home tab Modify panel. Move the BATH text between the bath-
room cabinet and shower, as shown in Figure 8.19.
4. Repeat the MOVE command by pressing , moving the KITCHEN text
to the position shown in Figure 8.19.
5. Click the LIVING ROOM text. One grip appears at the justification point.
6. Click the grip to activate it. The LIVING ROOM text is attached to the
cursor and moves with it (see the left of Figure 8.20).
The STRETCH command automatically starts. Because text can't be
stretched, the STRETCH command functions like the MOVE command.
7. Move the cursor just above the roof centerline near the middle of the
living room, and then click to place text at its new location.
Press Esc to deselect the text and remove the grip.
8. From the status bar, change the annotation scale back to 3 16 = 1 -0 .
The text size for each of the room labels gets larger, and the location
for the LIVING ROOM text reverts to its original location, as shown in
Figure 8.20 (right).
An annotative object displays at the scale assigned to it. When you created the
room labels, the annotation scale was set to 3 16 = 1 -0 , and so it was the scale
AutoCAD used to correctly size room labels. At that point, your room labels were
only set up to display at a scale of 3 16 = 1 -0 .
At the start of this exercise, you verified that the Add Annotation Scales but-
ton was turned on and then changed the annotation scale from 3 16 = 1 -0 to
¼ = 1 -0 . In doing that, you added the ¼ = 1 -0 scale to each of the three
annotative objects in your drawing. Your room labels were then set up to display
at both scales.
When plans are being prepared at different scales, it's often necessary to place
annotation objects such as text in different locations for some or all of the scales.
This is done to avoid conflicts with other objects in the drawing and to make
plans as readable as possible. This is the reason annotative objects allow you to
Search WWH ::




Custom Search