Combining Objects into Blocks - AutoCAD 2011 and AutoCAD LT 2011: No Experience Required - page 316

FiGuRE 7.10 The A-DOOR-36INblock attached to the cursor
6. The A-DOOR-036IN block is no longer attached to the cursor, and
its insertion point has been placed at the right end of the lower jamb
line. The block now rotates as you move the cursor (see the left of
Figure 7.11).
At the Specify rotation angle <0.00>: prompt, press ↵ again to
accept the default angle of 0°. The A-DOOR-36IN block properly appears
in the drawing (see the right of Figure 7.11).
FiGuRE 7.11 The rotation option (left) and the final placement (right)
Each time a block is inserted, you can specify the following on the screen or
in the Insert dialog box:
The location of the insertion point of the block
The X and Y scale factors
The Z scale factor in the dialog box (used for 3D drawings, in
AutoCAD only)
The rotation angle