Graphics Programs Reference
In-Depth Information
FiGuRE 5.60
Using Selecting Cycling to select the right edge of the counter
9.
Perform the following offsets to draw the sink basins.
a.
Offset the left side, bottom, and right side of the sink
1.5
″
(
38 mm
)
to the inside.
b.
Offset the top side
2.5
″
(
64 mm
) to the inside.
c.
Offset the left basin edge to the right
9
″
(
229 mm
).
d.
Offset the right basin edge to the left
1
′
7
″
(
483 mm
).
This forms the basis of the inside sink lines (see the middle of
Figure 5.61).
10.
Trim away the horizontal top and bottom inside sink lines between
the two middle vertical sink lines. Then, fillet the four corners of
each basin with a
2
″
(
51 mm
) radius to clean them up.
Use the Multiple option of the
FILLET
command so that you won't
need to restart the command continually.
11.
Fillet all four outside sink corners with a
1.5
″
(
38 mm
) radius.
This finishes the sink (see the bottom of Figure 5.61). Use Zoom
Previous to view the whole kitchen with the completed sink.
This completes the kitchen area. You drew no new lines to complete this task
because you created most of them by offsetting existing lines and then trim-
ming or filleting them. Keep this in mind as you move on to the bathroom.
Search WWH ::
Custom Search