Graphics Programs Reference
In-Depth Information
Drawing the Back threshold
The method of drawing the threshold for the back door is the same as the method
used to draw the front threshold. You will use Ortho mode, direct input, and Object
Snap Tracking to draw the lines. Here is how it's done:
1. Make sure 04A-FPLAY6.dwg is open.
2. Zoom and pan until the back door fills the drawing area.
3. Start the LINE command and place the cursor over the left corner of
the lower jamb.
Then, after the temporary tracking point cross appears inside the
endpoint marker, move the cursor directly downward, as shown in
Figure 5.9.
FiGuRE 5.9 Starting the rear threshold
4. Enter 3 ( 76 ) to set the start point of the line 3 (76 mm) below the
edge of the jamb.
5. Move the cursor directly to the left; then enter 2 ( 51 ) to draw the
lower edge of the threshold.
6. Finish the threshold by moving the cursor directly upward and entering
3'6” ( 1067 ).
 
Search WWH ::




Custom Search