Developing Drawing Strategies: Part 1 - AutoCAD 2011 and AutoCAD LT 2011: No Experience Required - page 158

8. Enter -45 ↵ . The door rotates 45º (see Figure 4.76), and the ROTATE
command ends.
FiGuRE 4.76 The first closet door panel is rotated.
9. Start the MIRROR command from the Home tab ➢ Modify panel, and
then select the closet door panel.
10. Verify that Ortho mode is still turned on in the status bar. If it's not,
click the Ortho Mode button or press the F8 shortcut key to turn on
Ortho mode.
11. At the Specify first point of mirror line: prompt, click the far-
left corner point of the selected panel.
12. Move the cursor either up or down until you see the mirror door
panel directly to the left of the first panel (see Figure 4.77); then click
to specify the second point of the mirror line.
FiGuRE 4.77 Mirroring the first closet door panel
13. Press ↵ to accept the default No option when prompted to erase the
source object.