Graphics Programs Reference
In-Depth Information
5.
Make sure the Object Snap and Object Snap Tracking buttons on the status bar are on;
then use the Endpoint Running Osnap to pick the corner where the upper horizontal wall
line meets the bathroom wall.
6.
Move the cursor over the Osnap marker so that the Osnap Tracking vector appears from
the corner. Now move the cursor to the right, and you'll see the Osnap Tracking vector
extend from the corner.
7.
Continue to move the cursor to the right so that the tracking vector readout shows
roughly 6˝, or 15 cm for metric users.
8.
With the cursor in this position, enter
5
↵. Metric users should enter
13
↵. The door is
placed exactly 5 (or 13) units to the right of the corner.
9.
At the Specify rotation angle <0>: prompt, enter
270
↵. Or, if you prefer, turn on
Polar Tracking to orient the door so that it's swinging
into
the studio. You've now accu-
rately placed the entry door in the studio apartment.
10.
Make sure the door is on the Door layer.
Next, add the finishing touches to the entry door:
1.
Add 5˝ (13 cm for metric users) door jambs as shown in the bottom image in Figure 6.19,
and change their Layer property to the Jamb layer.
