Graphics Programs Reference
In-Depth Information
70,230
@220,0
c(Close)
@0,70
@0,70
@60,0
Fig. 2.9
Fourth example - Line tool
Fifth example - Line tool ( Fig. 2.10 )
Another method of constructing accurate drawings is by using a method
known as
tracking
. When
Line
is in use, as each
Specify next point:
appears at the command line, a
rubber-banded
line appears from the last
point
entered. Drag
the rubber-band line in any direction and
enter
a
number at the keyboard, followed by a
right-click.
The line is drawn in the
dragged
direction of a length in units equal to the
entered
number.
In this example because all lines are drawn in vertical or horizontal
directions, either press the
F8
key or
click
the
ORTHO
button in the status
bar which will only allow drawing horizontally or vertically.
1.
Close the drawing and open a new
acadiso.dwt
window.
2.
Left-click
on the
Line
tool icon and
enter
fi gures as follows at each
prompt of the command line sequence:
Command:_line Specify fi rst point: enter 65,220
right-click
Specify next point: drag to right enter 240
right-click
Specify
145 right-click
Specify next point or [Undo]: drag left enter 65
right-click
Specify
next point:
drag
down enter
next point or [Undo]:
drag
upwards enter
25
right-click
Specify next point or [Close/Undo]: drag left
enter 120 right-click
Specify next point or [Close/Undo]: drag upwards
enter 25 right-click
Search WWH ::
Custom Search