Introducing drawing - Introduction to AutoCAD 2011: 2D and 3D Design - page 31

Specify next point or [Close/Undo]: enter 295,100
right-click
Specify next point or [Close/Undo]: enter 230,100
right-click
Specify next point or [Close/Undo]: enter 230,70
right-click
Specify next point or [Close/Undo]: enter 120,70
right-click
Specify next point or [Close/Undo]: enter 120,100
right-click
Specify next point or [Close/Undo]: enter 55,100
right-click
Specify next point or [Close/Undo]: enter 55,210
right-click
Specify next point or [Close/Undo]: enter c
(Close) right-click
Command:

The result is as shown in Fig. 2.6 .

80,235 275,235

55,210 295,210

120,100 230,100

55,100 295,100

120,70 230,70

Fig. 2.6 Second example - Line tool

Third example - Line tool ( Fig. 2.7 )

1. Close the drawing and open a new acadiso.dwt window.
2. Left-click on the Line tool icon and enter fi gures as follows at each
prompt of the command line sequence:

Command:_line Specify fi rst point: enter 60,210
right-click