Blocks and Inserts - Introduction to AutoCAD 2011: 2D and 3D Design - page 188

Note on the DesignCenter
Drawings can be inserted into the AutoCAD window from the
DesignCenter by dragging the icon representing the drawing into the
window ( Fig. 9.20 ).
Fig. 9.20 An example of a drawing dragged from the DesignCenter
When such a drawing is dragged into the AutoCAD window, the
command line shows a sequence such as:
Command: _-INSERT Enter block name or [?]:
“C:\Acad 2011 book\Chapter11\64
Pheasant Drive\Fig04.dwg”
Units: Millimeters Conversion: 1.0000
Specify insertion point or [Basepoint/Scale/X/
Y/Z/Rotate]: pick
Enter X scale factor, specify opposite corner,
or [Corner/XYZ] <1>: right-click
Enter Y scale factor <use X scale factor>:
right-click
Specify rotation angle <0>: right-click
Command: