Creating and Repairing 3D Scans - Make: 3D Printing - page 83

Figure 6-38. Reduce brush results

Export your file as an STL and then open it
up in NetFabb. See Figure 6-39 .
Slice and repair in netfabb
Use the same process detailed in “Repair
and Clean Up in netfabb” on page 72 to
slice off unwanted parts of the model,
repair the mesh, and then export it as a
binary STL. Your model should now be
capped, cropped, and ready for printing
( Figure 6-40 )!

Figure 6-37. MeshMixer Brushes

Figure 6-41 shows a photo of the final print-
ed model.