REFERENCES - Unsaturated Soil Mechanics in Engineering Practice - page 902

Slichter, C. S. 1899. Theoretical investigations of the motion of
groundwaters, in 19th Annual Report , Part 2, U.S. Geological
Survey, Washington, DC, pp. 295-384.
Smith, E. C. 1942. Soil mechanics: Factor of safety of clay banks,
Journal of the Institution of Civil Engineers , Vol. 18, No. 7,
pp. 293-296.
Smith, A. W. 1973. Method for determining the potential vertical
rise, PVR. Texas Test Method Tex-126-E, Proceedings of
Workshop on Expansive Clays and Shales in Highway Design
and Construction , University of Wyoming, Laramie, WY,
Vol. 1, pp. 189-205.
Smith, W. O. 1939. Thermal conductivities in moist soils, Soil
Science Society of America Proceedings , Vol. 4, pp. 521-524.
Snethen, D. R. 1986. Expansive soils: Where are we? Ground
Failure, No. 3, National Research Council Communication
on Ground Failure Hazards ,

of the Fifty-Seventh Canadian Geotechnical Conference ,Que-
bec City, QC, pp. 23-30.
Stoicescu, J. T., Haug, M. D., and Fredlund, D. G. 1998. The
soil-water characteristics of sand-bentonite mixtures used for
liners and covers, Proceedings of the Second International
Conference on Unsaturated Soils, UNSAT-98 , Beijing, Vol. 1,
pp. 143-148.
Stone, J. J., Bashir, R., and Fredlund, D. G. 2011. Effect of ambient
temperature on the calibration of thermal conductivity suction
sensors, Proceedings of the Canadian Geotechnical and Fifth
Pan American Conference , Toronto, ON, October 2-6.
Stormont, J. C., and Anderson, C. E. 1999. Capillary barrier effect
from underlying coarser soil layer, Journal of Geotechnical
and Geoenvironmental Engineering , Vol. 125, No. 8,

pp. 641-648.
Stormont, J. C., and Morris, C. E. 1998. Method to estimate water
storage capacity of capillary barriers, Journal of Geotech-
nical and Geoenvironmental Engineering , Vol. 124, No. 4,
pp. 297-302.
Streeter, V. L., and Wylie, B. 1975. Fluid Mechanics ,6thed.,
McGraw-Hill, New York.
Stylianou, C., and DeVantier, B. A. 1995. Relative air permeability
as function of saturation in soil venting, Journal of Environ-
mental Engineering , Vol. 121, No. 4, pp. 337-347.
Subba, R. K. S., and Satyadas, G. C. 1985. Measurement of volu-
metric and linear shrinkage on black cotton soil, Geotechnical
Testing Journal, ASTM , Vol. 8, No. 2, pp. 66-70.
Sullivan, R. A., and McClelland, B. 1969. Predicting heave of
buildings on unsaturated clays, Proceedings of the Second
International Conference on Expansive Soils , College Station,
TX, pp. 404-420.
Sun, H. W., Wong, H. N., and Ho, K. K. S. 1998. Analysis of
infiltration in unsaturated ground, in K. S. Li, J. N. Kay,
andK.K.S.Ho(Eds.), Slope Engineering in Hong Kong ,
Balkema, Rotterdam, pp. 101-109.
Sun, J., Rahardjo, H., and Fredlund, D. G. 1994. A technique to
perform coupled consolidation analysis using two independent
softwares, Proceedings of the First Congress on Computing in
Civil Engineering , Washington, DC, Vol. 1, pp. 849-856.
Sutton, W. G. L. 1943. On the equation of diffusion in a turbulent
medium, Proceedings of the Royal Society of London, Series
A, Mathematical and Physical Sciences , Vol. 182, No. 988,
pp. 48-75.
Swarbrick, G. E. 1995. Measurement of soil suction using the fil-
ter paper method, unsaturated soils, Proceedings of the First
International Conference on Unsaturated Soils, UNSAT-95 ,
Paris, Vol. 2, pp. 653-658.
Sweeney, D. J. 1982. Some in situ soil suction measurements in
Hong Kong's residual soil slopes, Proceedings of the Seventh
Southeast Asia Geotechnical Conference , Hong Kong, Vol. 1,
pp. 91-106.
Sweeney, D. J., and Robertson, P. 1979. A fundamental approach
to slope stability in Hong Kong, Hong Kong Engineering ,
pp. 35-44.
Tadepalli, R. 1990. Study of collapse behavior during inundation.
M.Sc. thesis, Department of Civil Engineering, University of
Saskatchewan, Saskatoon, SK, 276 p.
Tadepalli, R., and Fredlund, D. G. 1991. The collapse behaviour of
a compacted soil during inundation, Canadian Geotechnical
Journal , Vol. 28, pp. 477-488.

National Research Council,

Washington, DC, pp. 12-16.
Soil Moisture Equipment. 1985. Commercial Publications, P.O.
Box 30025, Santa Barbara, CA.
Spanner, D. C. 1951. The Peltier effect and its use in the measure-
ment of suction pressure, Journal of Experimental Botany ,
Vol. 11, pp. 145-168.
Spencer, E. 1967. A method of analysis of the stability of embank-
ments assuming parallel interslice forces, Geotechnique ,

Vol. 17, pp. 11-26.
Spencer, E. 1968. Effect of tension on stability of embankments,
Journal of Soil Mechanics Foundation Engineering Division,
ASCE , Vol. 94, No. SM5, pp. 1159-1173.
Spencer, E. 1973. Thrust line criterion in embankment stability
analysis, Geotechnique , Vol. 23, pp. 85-100.
Sposito, G. 1981. The Thermodynamics of Soil Solutions , Oxford
Clarendon, London.
Sridharan, A., Altschaeffl, A. G., and Diamond, S. 1971.
Pore size distribution studies, Journal of Soil Mechanics
and Foundation Engineering, ASCE , Vol. 97, No. SM5,

pp. 771-787.
Sridharan, A., Rao, A. S., and Sivapullaiah, P. V. 1986. Swelling
pressure of clays, Geotechnical Testing Journal, ASTM ,
Vol. 9, No. 1, pp. 24-33.
Stalhane, B., and Pyk, S. 1931. New method for determining the
coefficients of thermal conductivity, Teknisk Tidskift , Vol. 61,
No. 28, pp. 389-393.
Stannard, D. I. 1992. Tensiometers-Theory, construction and
use, Geotechnical Testing Journal, ASTM , Vol. 15, No. 1,
pp. 48-58.
Stianson, J., Fredlund, D. G., and McArthur, T. 2010. Climate
classification and quantification for cover design in cold
environments, Proceedings of the Third International Con-
ference on Uranium , Uranium 2010, Saskatoon, SK, Vol. 2,
pp. 455-468.
Stianson, J., Fredlund, D. G., and Chan, D. 2011. Three-
dimensional slope stability based on stresses from a
stress-deformation analysis, Canadian Geotechnical Journal ,
Vol. 48, No. 6, pp. 891-904.
Stianson, J. R. 2008. A three-dimensional slope stability method
based on finite element stress analysis and dynamic program-
ming, PhD Thesis, University of Alberta, Edmonton.
Stianson, J. R., Chan, D., and Fredlund, D. G. 2004. Comparing
slope stability analysis based on linear elastic or elasto plastic
stresses using dynamic programming techniques, Proceedings