Control Tests for Concrete - Design and Control of Concrete Mixtures - page 290

Kosmatka, Steven H., “Floor-Covering Materials and
Moisture in Concrete,” Concrete Technology Today, PL853 ,
Portland Cement Association, http://www.portcement.
org/pdf_files/PL853.pdf , September 1985, pages 4 and 5.

Pfeifer, D. W., and Scali, M. J., Concrete Sealers for Protection
of Bridge Structures, NCHRP Report 244, Transportation
Research Board, National Research Council, 1981.
Pinto, Roberto C. A., and Hover, Kenneth C., Frost and
Scaling Resistance of High-Strength Concrete, Research and
Development Bulletin RD122 , Portland Cement Asso-
ciation, 2001, 70 pages.
Pistilli, Michael F., and Willems, Terry, “Evaluation of
Cylinder Size and Capping Method in Compression Test-
ing of Concrete,” Cement, Concrete and Aggregates,
American Society for Testing and Materials, West Consho-
hocken, Pennsylvania, Summer 1993.

Kosmatka, Steven H., “Petrographic Analysis of Con-
crete,” Concrete Technology Today, PL862 , Portland Cement
Association, http://www.portcement.org/pdf_files/
PL862.pdf , 1986, pages 2 and 3.

Lawrence, Deborah J., “Cement and Water Content of
Fresh Concrete,” Significance of Tests and Properties of Con-
crete and Concrete-Making Materials, STP 169C, American
Society for Testing and Materials, West Conshohocken,
Pennsylvania, 1994, pages 112 to 120.

Powers, Laura J., “Developments in Alkali-Silica Gel
Detection,” Concrete Technology Today, PL991 , Portland
Cement Association, http://www.portcement.org/pdf_
files/PL991.pdf , April 1999, pages 5 to 7.

Malhotra, V. M., Testing Hardened Concrete, Nondestructive
Methods, ACI Monograph No. 9, American Concrete
Institute-Iowa State University Press, Farmington Hills,
Michigan, 1976.

Powers, T. C., “Studies of Workability of Concrete,”
Journal of the American Concrete Institute, Volume 28, Amer-
ican Concrete Institute, Farmington Hills, Michigan, 1932,
page 419.

Malhotra, V. M., In Situ/Nondestructive Testing of Concrete,
SP-82, American Concrete Institute, Farmington Hills,
Michigan, 1984.

Malhotra, V. M., and Carino, N. J., Handbook on Non-
destructive Testing of Concrete, ISBN 0-8493-2984-1, CRC
Press, Boca Raton, Florida, 1991, 343 pages.
Mor, Avi, and Ravina, Dan, “The DIN Flow Table,”
Concrete International, American Concrete Institute, Farm-
ington Hills, Michigan, December 1986.

Powers, T. C., The Properties of Fresh Concrete, Wiley, New
York, 1968.

Powers, T. C., and Wiler, E. M., “A Device for Studying the
Workability of Concrete,” Proceedings of ASTM, Volume 41,
American Society for Testing and Materials, West Consho-
hocken, Pennsylvania, 1941.

NRMCA, Concrete Tool Box, Version 4.0.2, National Ready
Mixed Concrete Association, Silver Spring, Maryland,
2001.

Saucier, K. L., Investigation of a Vibrating Slope Method for
Measuring Concrete Workability, Miscellaneous Paper 6-849,
U.S. Army Engineer Waterways Experiment Station,
Vicksburg, Mississippi, 1966.

NRMCA, In-Place Concrete Strength Evaluation—A
Recommended Practice, NRMCA Publication 133, revised
1979, National Ready Mixed Concrete Association, Silver
Spring, Maryland, 1979.

Scanlon, John M., “Factors Influencing Concrete Work-
ability,” Significance of Tests and Properties of Concrete and
Concrete-Making Materials, STP 169C, American Society for
Testing and Materials, West Conshohocken, Pennsylvania,
1994, pages 49 to 64.
St. John, Donald A.; Poole, Alan W.; and Sims, Ian, Con-
crete Petrography—A handbook of investigative techniques,
Arnold, London, http://www.arnoldpublishers.com ,
PCA LT226, 485 pages.
Steinour, Harold H., Influence of the Cement on Corrosion
Behavior of Steel in Concrete, Research Department Bulletin
RX168 , Portland Cement Association, http://www.port
cement.org/pdf_files/RX168.pdf , 1964, 22 pages.
Tabikh, A. A.; Balchunas, M. J.; and Schaefer, D. M., “A
Method Used to Determine Cement Content in Concrete,”
Concrete, Highway Research Record Number 370, Trans-
portation Research Board, National Research Council,
Washington, D.C., 1971.

NRMCA, “Standard Practice for Rapid Determination of
Water Soluble Chloride in Freshly Mixed Concrete,
Aggregate and Liquid Admixtures,” NRMCA Technical
Information Letter No. 437, National Ready Mixed Concrete
Association, March 1986.

Parry, James M., Wisconsin Department of Transportation
QC/QA Concept, Portland Cement Concrete Technician
I/IA Course Manual, Wisconsin Highway Technician Cer-
tification Program, Platteville, WI, 2000, pages B-2 to B-4.

PCA Durability Subcommittee, Guide Specification for Con-
crete Subject to Alkali-Silica Reactions, IS415, Portland
Cement Association, 1998

PCA, “Rapid Analysis of Fresh Concrete,” Concrete Tech-
nology Today, PL832 , Portland Cement Association, http:
//www.portcement.org/pdf_files/PL832.pdf , June 1983,
pages 3 and 4. Tattersall, G. H., Measurement of Workability of Concrete,

East Midlands Region of the Concrete Society of
Nottingham, England, 1971.

PCA, Understanding Concrete Floors and Moisture Issues,
CD014, Portland Cement Association, 2000.