Hardware Reference
In-Depth Information
until you need it another time correctly orient the i/o shield at the back in the case then
press firmly
on each of the four corners until they snap into place
Corsair kindly pre-installed the standoffs in their cases
so just put them back in the war through the i/o shield
man lower it into place course are also kindly replaces the screw threads a little standoff
with a little post that holds the motherboard therefore you
well you do what the eight screws around it here here here here
here here here and here for the front panel i/o
power and reset are not affected by orientation so just checked the spots for them in the
motherboard manual and plug them in
the power and drive activity LED is do need the positive pen to correspond to the correct
wire however
so if they're not working just try flipping around don't worry you won't damage anything
front USB only goes in one way thanks to the chain connector
while front USB to an audio are a little bit trickier
just look closely for the block of pin on the cable
and the missing pin on the header the wire for that then that we install the back can be either
managed behind the fan frame
or slipped up to be shorter than plugged into the nearest fan header don't worry that their
four pin headers on the board
-pin fans for work just fine on now I'll be the first to admit that I don't know enough about
electrical engineering to properly evaluate a power supply
on that level and even if I did I don't have anything resembling the necessary equipment to
do it
anyway but what I do know is where to find the best power supply reviews on the internet
johnnie good I can't tell why did I choose the Coolermaster v power supply
well because I want rock-solid efficiency a nice sexy I D
nice cables on a modular interface a lower think I want the power supply that had abso-
lutely nothing listed in the con- section at the end over John Eagle a review
and the story watt will be enough for our rate but if we wanted some growing room
the me one thousand as an option as well were using a modular power supply so rather than
worrying about cables right off the bat we're just going to slide the PSU into its position
fan side down at the bottom with the case where there's a
filtered and take then use the four screws included in the box to secure it at the back
next to grab the pin cable a penny PS cable
to PCI Express power cables a couple say the power cables
and of -pin molex cable this should be enough for us to power the whole system plug the
-pin and a penny PS connectors interior motherboard
Search WWH ::
Custom Search