Hardware Reference
In-Depth Information
4.
Install the heatsink. If the heatsink uses push pins (see
Figure 19.10
)
, make sure the
pins are rotated in the proper position. The tops should be turned in the opposite dir-
ection of the arrows on top. Set the heatsink on the processor such that the four pins
engage in the holes surrounding the socket. Then push down each of the four pins
until they click or latch into place. This can take more force than you might think is
prudent, so be sure to visually inspect the installation to ensure that all four pins have
fully engaged and are locked. Some heatsinks use one or more retainer clips (see
Fig-
ure 19.11
). With this type you must be careful when attaching the clip to the socket;
you don't want it to scrape against the motherboard, which can damage circuit traces
or components. You also need to keep the heatsink steady on the chip while attaching
the clips, so do not move, tilt, or slide the heatsink while you attach it.
Figure 19.10
An Intel heatsink being installed on an LGA1155 processor.
