Graphics Programs Reference
In-Depth Information
Figure 11.11
Water source heat pumps
8. Choose Systems Mechanical Equipment, and start placing the water
source heat pumps (type 006) into each room. If needed, you can use
the spacebar before placing the equipment to rotate it 90 degrees. After
you have placed all the heat pumps into the model, right-click the water
source heat pump you first placed and choose All Instances Visible In
View. Then, in the Properties palette, change the Offset parameter to
9′-0″ (2,750 mm). This will allow you to set the correct elevation of
equipment (see
Figure 11.12
)
.
Figure 11.12
Verifying the offset for the correct elevation
