Graphics Programs Reference
In-Depth Information
Figure 9.8
). The standard Supply Diffuser that comes with the Revit install
can be a good place to examine connectors.
Figure 9.8
Parameters for duct connection
If the connector system classification is set to Fitting, the connector has
only six parameters. Revit MEP has several system classifications available
for duct connections that facilitate system creation and view filters within a
project (see
Figure 9.9
).
Figure 9.9
System classifications for duct connections
Starting at the top, here is an explanation of each duct connector parameter
shown in
Figure 9.8
:
Flow Factor
This parameter determines the percentage of the system
flow that will be seen by the connector. It is available only when Flow
Configuration is set to System. It is useful when using multiple devices,
each of which is sized for part of the load.
