Hardware Reference
In-Depth Information
Figure 3-8
Because the force-sensing resistors melt easily, I used 30AWG wire
wrap instead of solder. Wire-wrapping tools are inexpensive and
easy to use, but make a secure connection. After wire wrapping,
I insulated the connections with heat shrink. (Heat shrink not
shown.)
Figure 3-9
The cat-sensing panel. The four FSRs are wired in parallel. Note the
rubber feet that press down more precisely on the sensors. Make
sure to insulate the connections before taping the panels together.
The connector is just a pair of female wire-wrap headers.
