Graphics Reference
In-Depth Information
Figure 21-11. Insert the feed cylinder into the hole on Part S.
Look carefully at Figure 21-11 and you'll notice that the empty hole in the upper-right corner, if
drilled, would cause the wood screw to impact the 2-1/2" bolt holding Part S to Part Q. If this is the case,
flip the Extruder around and you should find that the empty hole is not in line with the 2-1/2" machine
screw. Mark all four holes with a pencil and drill pilot holes, as shown in Figure 21-12.
Search WWH ::
Custom Search