Graphics Reference
In-Depth Information
Figure 21-2. Insert Allen screws into mounting plate and secure with nuts.
Use a sharp blade to cut away a square on top of the Extruder. You will be cutting away the Kapton
tape and the ceramic tape below it to expose the four screw holes shown in Figure 21-3.
■
Note
Take your time with this and cut away a small square at first, and then enlarge little by little until you find
the screw holes. If you'd rather avoid cutting away this much of the Kapton and ceramic tape, you can try to cut
small Xs in the four corners and just peel back the tape to find the holes.
Search WWH ::
Custom Search