Graphics Reference
In-Depth Information
Figure 18-22. Set the depth of the screw to trigger the endstop's pushbutton.
You'll next mount the table's endstop. To do this properly, push the table to the back of the machine
as far as you can without risking the Strong-Tie's leaving the v-groove bearings. You'll want to mount the
endstop in a location on the right-rear side of the machine, as shown in Figure 18-23 (yes, the endstop is
upside down right now, but it's just leaning against the Lower Structural Side to find the best mounting
location). Find a location where you can screw in the two #4-5/8” screws and use two 1/4” deep nylon
spacers to allow the endstop's pushbutton to be over the table (and not the gap between the table's edge
and the Lower Structural Side).
Search WWH ::
Custom Search