Graphics Reference
In-Depth Information
Figure 18-11. A Molex extender connected to the power supply
You now have two free male ends that can have splitters attached as well; this will allow you to
daisy-chain more splitters so you can reach the motor drivers and Extruder controller. As with previous
wiring of components, you'll want to use zip ties to pull the various wires out of the way of moving parts.
And be certain to use enough Molex extenders to allow for slack and full movement of the lead screw,
table, and other moving assemblies.
Figure 18-12 shows a final splitter reaching the Z-axis motor driver. Note that one free male end is
left. You can cut the four wires back near the female end of the splitter to reduce wire clutter.
Search WWH ::
Custom Search