Graphics Reference
In-Depth Information
Figure 17-13. Secure the thermocouple wire ends to the Extruder Controller.
Connect the Power Resistor Wires
Locate the two wires that are connected to the two power resistors that were bolted to the side of the
Extruder's heater core. These two wires will now be attached to the Extruder Controller..
You'll connect these two wires to the screw terminals labeled HEATER (there are two screw
terminals under the word HEATER). It doesn't matter which wire goes into which screw terminal.
Figure 17-14 shows these two wires secured to the Extruder Controller. If you look closely, you can
just make out HEATER behind the two wires.
Search WWH ::
Custom Search