Motors and Movement - Printing in Plastic: Build Your Own 3D Printer - page 237

Figure 13-27. The belt wrapping over the bearings and around the pulley
Carefully insert the Table between the v-groove bearings. You're going to secure one end of the belt
to one end of the Strong-Tie bracket using a single #8 x 3/4” machine screw (1/2” length will also work),
four fender washers, and a nut. Two washers will be on one side and two washers and the nut on the
other. You will feed the belt between the washers on one side, around the Strong-Tie bracket, through
the other two washers, and then tighten the nut to hold the belt securely. Figure 13-28 shows one end of
the belt held in place with the washers.