Graphics Reference
In-Depth Information
Figure 13-21. Add the Table and adjust nuts until the Table rolls smoothly.
Adding Belts to X and Y Axes
The final task for this chapter will be to add the belts to the X and Y motors. You'll start by cutting the two
belts (that are sold as a looped belt) and setting them aside until needed.
Next, use two #8-32 machine screws (you can also use 1-1/4” machine screws) through the holes at
the top of the Upper Structural Side to hold the small metal bracket in place, as shown in Figure 13-22.
 
Search WWH ::




Custom Search